Richtiger Modus????

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • HI

    Ich wollte nur wissen wenn ich mein interface von DE anschließe und daran dann DMX out zu den geräten gehen soll und DMX in zum PC, dann müsste ich doch den Modus 6 PC Out = DMX Out & DMX In = PC In wählen, oder?

    mfg Klaus

  • Hallo Klaus, sieht gut aus. Modus 6 ist in der Regel die richtige Wahl :o)

    Wenn der Modus nicht die richtigen Ergebnisse liefert, könnte es daran liegen, dass Du die falschen Buchsen angeschlossen hast (an DMX-Thru kein Kabel anschließen).

    Schwerpunkt: Musicals
    Software: DMXC 2.10 / grandMA onPC / ArkaosVJ
    Hardware: DE IF / MA 2Port-Node
    Geräte: EL-40, TS-2, Scantech 150, div. Strobes, Moon- & CAT-Lights, Flower, Derbys, 1 Center-Effekt u.e.m.
    PARs: 4*LED-RGB,2*P56,16*P64,30*P36,10*P16
    Nebel: 2*1000W,700W,Fazer + 70cm-Ventilatoren

  • Hallo,
    ja die gibt es, und zwar im Projektarchiv des DE-Interfaces auf der DE-Homepage oder jetzt von mir:

    Zitat aus "Beschreibung.txt" aus dem Projektarchiv:
    0: Do nothing - Standby
    1: DMX In -> DMX Out
    2: PC Out -> DMX Out
    3: DMX In + PC Out -> DMX Out
    4: DMX In -> PC In
    5: DMX In -> DMX Out & DMX In -> PC In
    6: PC Out -> DMX Out & DMX In -> PC In
    7: DMX In + PC Out -> DMX Out & DMX In -> PC In

    Viele Grüße
    JP

    im Falle eines Falles klebt Gaffa einfach alles, denn Gaffa ist dein Freund und Helfer :thumbup:

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.