Verkaufe GLP SCAN OPERATOR 12 PT ADVANCED

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • Hi Leute ich verkaufe meinen alten
    GLP SCAN OPERATOR 12 PT ADVANCED + fast neuem Case

    der Scan Operator ist leicht deffekt(Bedienung geht schwer (also die tasten), aber prinzipiell wenn sich jemand auskennt voll funktionstüchtig.


    Wenn jemand interesse hat das ding ist eingecased.
    Bilder auf Anfrage wenn sich niemand findet stelle ich es in Ebay.

    Gruß Chris

  • Bilder sind immer gut. :)

    [Blocked Image: http://i49.tinypic.com/fe2d10.jpg]
    DMXControl 2.10.5
    2x nvent Open CoreDMX IF, 2x billig Variante
    4x GLP MAX ;2x IMG Stageline TWIST 252
    2x Eurolite TS3 ;4x Stairville LED PAR 56
    3x 4ch. Dimmerpacks ;1x STAIRVILLE SF-1000;1x Profog K120,
    1x Blinder ;12x PAR 56 short ;8x LED PAR 56
    1x 1500W Strobe ;1x UV Fluter
    1x STAIRVILLE DMX-MASTER I
    1x SHOWTEC SHOWMASTER 24
    1x DMX Controller mit Batterie
    1x Beamer
    kleine Effekte

  • Ok wenn ich heute Abend zu Hause bin werde ich die Bilder hier hochstellen.

    Preisvorstellung habe ich keine ich glaube hier gibt es junge Leute die noch nicht so viel Geld haben, also würde ich das Teil sehr günstig abgeben. Np war mal 200 Euro + 50 Euro Case.

    ich hatte an 50 Euro oder so gedacht + 20 Case und Versand.

    Ich nehmen gerne eure Vorschläge an.

  • Sry Jungs hatte gestern Abend keine Zeit um Bilder zu machen. Wenn du in Mannheim wohnst kann du das Teil gerne bei mir abholen ansehen, wohne nicht weit davon weg :)


    Gruß Chris

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.