Did you know? #13 - Swapping pan and tilt
-
LightningBrothers
-
June 25, 2018 at 10:00 AM -
2,847 Views -
0 Comments
Normally, you can use your moving lights in nearly every orientation in your stage setting. In the most cases the devices standing in the upright position on the floor or hanging downwards in the rig. Those light setups are easy to control although you might invert the pan and / or tilt axes of your devices. However, devices mounted in an other orientation like you can see in the visualization are much harder to control. Then you start to ask your self: How do I set the position correctly and how I have to set the orientation of the motion patterns for creating a consistent look?
A small feature in the Device Properties can handle this problem and saves you labor. DMXControl 3 can switch the pan and tilt axis of a moving light. After activating this feature for the moving lights at the outer truss stands in our example, all devices can be controlled as if they are standing upright or hanging upside down. Take a look at the values in the Device Control.
According to your light setup it could be necessary to additionally add an offset to the tilt axis or to invert the pan and / or tilt axes. As always: Try it yourself which combination of the above mentioned features are the best for a specific use case.
Your
DMXControl-Team ![]()
Comments
Newly created comments need to be manually approved before publication, other users cannot see this comment until it has been approved.
Newly created comments need to be manually approved before publication, other users cannot see this comment until it has been approved.