Hello! I am looking for some help with the ArtNetSharp library.
I am trying to figure out the types in this constructor for a portconfig. public PortConfig(in byte bindIndex, in Net net, in Address address, in bool output, in bool input) : this(bindIndex, new PortAddress(net, address.Subnet, address.Universe), output, input)
Spefically what Net and Address look like. Are these references to an IP address? How would they need to be formatted?
I want to make a port that communicate with IP address 10.0.33.20 on network 10.0.33.0/24
Constructor help ArtNetSharp and PortConfig
-
mcastrigno -
April 2, 2025 at 6:30 PM -
Thread is Resolved
We proudly present: The release of DMXControl 3.3.3!
On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!
-
The Library is Artent 4 its not nesseccery to specify any IP-Adresses.
Your Artnet-Interfaces have to send ArtPollReplys on ArtPoll.It the Interface is Matching Net and Adresse (Equal to PortAddress) the Library start to Comunicate with the interface
See https://art-net.org.uk/downloads/art-net.pdf Page -10- -
Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
