Hey,
ich versuche mit DMX C3 das Interface MK2 von Enttec anzusteuern. Leider wird von DMXC3 nur ein Universum erkannt. Was kann ich tun? Ist eine Lösung bekannt???
Vielen Dank im voraus!
Enttec MK2 Interface nur ein Universum erkannt
-
Matthias588 -
May 14, 2018 at 5:47 PM -
Thread is Resolved
We proudly present: The release of DMXControl 3.3.3!
On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!
-
Hallo,
welches MK2 von Enttecmeinst Du denn ?
Gruss Steff
-
Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
