Enttec OpenDmx USB suddenly stops working

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • I had the thing running for a few days, and now it has stopped, I think after I installed DMX Control 2 to handle the timing issues addressed in another thread. Freestyler still drives the lights, so I doubt it is a hardware issue.

    Is the port supposed to be 0 and the DMX-Out Address supposed to be 1.1? I have the interface enabled and DMX-Out enabled, and I'm using the same setup that worked a couple of days ago, but nothing.

    Any ideas?

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.