enttec OpenUSB

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • I just purchased an Enttec OpenUSB Widget.

    http://www.enttec.com/dmxusb.php

    and Im trying to get it going with DMXControl.
    however it dosnt seem to have the output plugin there to configure.
    .
    please tell me how to do this, and or provide a current link to the download I need

    thanks

    Jay Binks

  • I now have this plugin installed and I can select the output plugin..

    however it dosnt seem to "Connect" to the device (like other software does..)

    with other software I ahve played with, I have the option to connect to my DMX Moving lights (which is what Im playing with)... when I connect to the lights they return to the "Home" position and stop their automatic, sound activated mode and they enter DMX Mode... this happens when I connect to the OpenDMX controller (With other software)

    but I cant make this happen with DMXControll (Yet)

    I have got the output plugin in the correct directory, I can see it in the output plugin list.

    I have a check mark beside it, and I have got the Frames per Sec set to 25 (which works in the other apps)

    please how do I tell it to Connect or Go Online or something...

    Thanks

    Jay..


    PS.. I have tried setting up devices in DMXControll that are set to the same chanels as my lights.. but again it dosnt seem to do anything :(

    little help please :P

  • It seems to have problems with DMXControl. It works fine with Freestyler and works on my main PC fine, but a new laptop has delayed output, and if I select a fader from the submaster it may or nor register the output.

    Hippy (the author) is doing a rewrite of the plugin to try to overcome the incompatability

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.