Hallo Leute,
ich hab mal ne frage, wie ist denn die Pinbelegung der DMX-Out/In ports vom DE if?
also was ist Pin1 Pin2 Pin3?
Viele Grüße,
Marcel
Pinbelegung DE-IF
-
- DE Interface
-
mado -
March 9, 2011 at 10:19 PM -
Thread is Resolved
We proudly present: The release of DMXControl 3.3.3!
On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!
-
kuck dir mal das layout*.jpg im projektordner an. da siest du wo pin 1 ist.
(kann man jetzt nur so beschreiben: wenn du auf die connector kuckst ist links pin1)gruß
ulli -
Pin 1 ist Pin 3 an der XLR-Buchse, Pin 2 -> Pin 2, Pin 3 -> Pin 1
Steht aber auch in der Bauteil-Liste.txt drin. -
Souko April 9, 2018 at 7:27 PM Added the label DE Interface -
Souko
April 9, 2018 at 7:29 PM Moved the thread from forum DE Interface to forum Digital Enlightenment. -
Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
