DMX in Fernsteuerung

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • Hallo,

    ich hab ein kleines Pult (Stairville DMX Master I) an den DMX-In des FX5 Interfaces gesteckt und möchte DMX-Control und das Pult gleichzeitig nutzen.
    Das DMXin Fernsteuerungsfenster ist offen, es kommen dort aber keine Signale an.
    Was mache ich falsch?

    8x Stairville PAR 64 RGB LED
    2x ADJ Mega Pixel LED, 1x ADJ Mega Bar pro, 2x Eurolite Mat Bar
    2x ADJ Tri Phase, 2x Stairville MH X-25, 2x ADJ X-Move
    2x ADJ Revo Scan, 1x ADJ Double Feature

  • Richtigen Mode am Interface gewählt?

    Edit:
    Die passende Einstellunge für dich wird der Mode6 sein:
    PC-Out -> DMX-Out
    DMX-IN -> PC-IN

    Edited once, last by Phasm (October 14, 2010 at 6:07 PM).

  • Das scheint es gewesen zu sein. Zumindest habe ich Aktivität am DMXin Control und im Easy View tut sich auch was. Werd mal noch Hardware anhängen und testen - aber ich denk mal, das passt.

    Danke für den Tipp.

    8x Stairville PAR 64 RGB LED
    2x ADJ Mega Pixel LED, 1x ADJ Mega Bar pro, 2x Eurolite Mat Bar
    2x ADJ Tri Phase, 2x Stairville MH X-25, 2x ADJ X-Move
    2x ADJ Revo Scan, 1x ADJ Double Feature

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.