Dmx Stepper Henne Firmware anpassen

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • Hallo Leute,


    kann mir jemand erklären wie man die Stepper Firmware vom Henne anpassen Kann?

    ich möchte nach Möglichkeit ein Goborad mit festen Schrittwinkeln ansteuern,

    zB DMX Wert 0-30= Gobo 1,30-60=Gobo 2 usw

    insgesammt hat das Goborad 7Gobos (6+offen),baugleich Ypoc,MH660,Servospot

    ein Farbrad,drehbares 5fach Prisma und drehbare Gobos

    Ziel ist es zwei Showtec Dreamern(250MSD) wieder leben einzuhauchen,da die Elektronik nicht lieferbar ist(defekt,fehlt)

    leider bin ich der Programmiersprache nicht mächtig,:argh:

    aber nen AVR zu beschreiben ist möglich


    Viele Grüße vom

    Ha-Pe

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.