Timingproblem bei H.Hoelscher's RDM Interface

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!

    Hallo zusammen,
    Ich habe das USB interface (FT232R) von Hendrik Hoelscher gebaut, ebenso den Analyser. Es funktioniert alles wunderbar. Nur zeigt der Analyser zu hohe Breakwerte an: ca.3000uS (normal wären 176 bis 352) . Frage: liegt es am Interface oder Steuersoftware?
    Gruss aus Berlin

    PS: Gibt es für den Servo- transceiver im Movinglight betrieb eine eigene Software?

    Edited 2 times, last by Andreas99 (October 12, 2009 at 12:11 AM).

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
    • :argh:
    • :shit:
    • :)
    • :(
    • ;)
    • :P
    • ^^
    • :D
    • ;(
    • X(
    • :*
    • :|
    • 8o
    • =O
    • <X
    • ||
    • :/
    • :S
    • X/
    • 8)
    • ?(
    • :huh:
    • :rolleyes:
    • :love:
    • 8|
    • :cursing:
    • :thumbdown:
    • :thumbup:
    • :sleeping:
    • :whistling:
    • :evil:
    • :saint:
    • <3
    • :!:
    • :?:
    • :glaskugel: