Update DMX value

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • Hello,

    I have developped an interface USB-DMX which supports RDM assignation. This interface will be soon available.

    I have developped a plugin for DMX Control, because it's a great software. I have based this plugin on an demo in delphi proposed on the wiki.

    To update the value of DMX it uses :
    TOutputPlugin.SetChannel(Channel, Value: Integer);

    But there is a problem with this function. When we use Flash button on the soft, all value aren't update in same time (there is often a little latency and this is visible on a RGB led driver).

    So my question, is there an other function which permits to update a lot of value in same time? (The function will receive in paramaters a vector). Or is there a signal (variable) which prevents the plugin that a flash button is pressed and so there is a lot of value to update?

    I hope you understand my question. Sorry for my poor english

    Best regards

    Benjamin

  • Hi,

    first of all, I measured the time, DMXControl needs to change values on 512 DMX Ch at once.
    On my system (Athlon XP 3200+) it took between 47 an 63 milliseconds.

    So what you could do is to buffer the values in an array then send them all at once with a timer (30ms interval?).
    To be sure that they are not send until every Ch has the value that it should have, as you said with flash and RGB, R and G have the new values then before B would get its value the array is send to the interface, you could measure the time between 2 function calls of SetChannel, if the time is higher than a few ms you can be sure that no flash button is pressed and then send the new values to the interface.
    To be sure that under bad conditions this method will not produce a high delay you should count how often you haven't send the values and if its to often just send the values.

    I never tried this, but i think it could work.
    Also I don't know how other plugins handle this, maybe the developers can tell more about this.

    Will this be a commercial interface or will you publish schematics and firmware?

    Dennis

  • Hello!

    In fact my plugin work like this:

    It have a first thread, common with DMX Control, which catch all value by the setchannel function and write this in a Array. This Array is share with an other thread which read it and send value to the controler. By this way I'm sure to send all the time the value without freezing dmx Control.

    The interface USB-DMX is developped for costumers of my company. Our LED driver are Fully RDM and so they need it to configure. So I can't distribue the schematics and firmware of the interface (But I think that the price will be low). The plugin will certainly be open source. It can be use for a fully functionnal example to show how to program the interface.

    Best Regards

    Benjamin

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.