Hallo,
ist es irgendwie möglich Grandma 3d und DMXControl über ArtNet oder ähnliches zu "koppeln"? Wenn ja wie?
Über die Sufu und in der Wiki hab ich leider nichts gefunden.
Vielen dank für Antworten
mfg
Paynemaster
Grandma 3D und DMXControl
-
paynemaster -
October 6, 2008 at 4:39 PM -
Thread is Resolved
We proudly present: The release of DMXControl 3.3.3!
On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!
-
Souko April 9, 2018 at 8:31 PM Moved the thread from forum Hilfe zur Software [v2] to forum Help and Support [v2]. -
Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
