Output Interface development

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • Hi all,

    I am currently designing a USB->DMX interface, now I am aware there are many freeware option on the net for DMXC as I have been using the Enttec open source hardware for about 2 years now with no major problems.

    My USB->DMX interface will have the option of either being controlled by DMXC or being used in a stand alone mode. I have found that I sometimes need a simple stand alone controller.

    Now I need to know where can I obtain documentation on the output.dll, I need some idea of the API commands DMXC needs to communicate with output hardware.

    Many Thanks
    DJ_ABu-D

  • Hi Markus,

    I have tried the Delphi examples and they just crash DMXC, I am compiling them using Borland Developers Studio 2006 ( I think this is where my problem is ). I have Delphi 7 at home so I will retry the existing examples off the DMXC site.

    My hardware is a HID class USB interface and therefore does not use any driver dll, so I need to write my own out.dll for DMXC so I can debug my uP source code. If you could email your source it would be a great starting platform for me.

    Am I correct in understanding that all the output hardware needs is an Activate command, a Deactivate command, a Config command and finally a Send command? I might include DMX Rx later once I get my current source code running, so then I would have to add a Recieved command?

    Thanks in advance
    DJ_ABu-D

  • here is my plugin DMXC PlugIn_RGB LED-Modul

    I've compiled it with Delphi7, but it should also work with the free Turbo Delphi Compiler

    This PlugIn uses the COM-Port, emulated by a FT232R, to output the DMX values. Of course there are a lot of driver Files (c_port) which aren't important for you

    It's right that you need all these events, but where's the problem? e.g. in the activate event you open the connection to your hardware. You'll see in my plugin

    i hope this would help
    markus

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.