Hi, I am trying to create a device using arduino and a DMX / RDM shield to give an address to a DMX/RDM slave. However every example and library I found online only allows the arduino DMX control as a master, or DMX/RDM control from another master (that means arduino is a slave, which already has a DMX start address-not my point). More specific, I have a set of 10 lights, each one is RGBW (4 footprints) and I want using the arduino to be able to set their addresses accordingly at will. Any ideas?? Thank you very much in advance!
DMX RDM addressing using arduino
-
Crypt0n1um -
April 10, 2024 at 8:42 PM -
Thread is Resolved
We proudly present: The release of DMXControl 3.3.3!
On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!
-
-
JPK April 10, 2024 at 9:51 PM Approved the thread. -
GitHub - someweisguy/esp_dmx: Espressif ESP32 implementation of ANSI-ESTA E1.11 DMX-512A and E1.20 RDMEspressif ESP32 implementation of ANSI-ESTA E1.11 DMX-512A and E1.20 RDM - someweisguy/esp_dmxgithub.com -
Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
