Combining DMX values from two sources

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!

    Hi all,

    I'm using Resolume Arena (video playback software) to drive some LED strips via ArtNet, and I was wondering if it's possible to configure DMXC3 to combine the DMX values from Resolume with values from an LED Driver device in DMXC3 on a HTP basis so that I have the option to control the LED strips using either piece of software?


    I would imagine this is possible using the Input Assignment, but I've had a look at the Input Assignment nodes and I'm unsure how I would combine these two sources and output to DMX.

    I presume I can read the values that Resolume is outputting using the "DMX-In" nodes, but I'm unsure what node I would use to read the values from the LED Driver Device in DMXC3?

    Additional information: I have 6 LED strips, and each LED strip uses 6 channels - Dimmer, R / G / B / W, Strobe. I've already created & tested a device in DMXC to control these.

    Any advice on whether this is possible and how to configure it would be much appreciated!

    Cheers,

    Phil

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
    • :argh:
    • :shit:
    • :)
    • :(
    • ;)
    • :P
    • ^^
    • :D
    • ;(
    • X(
    • :*
    • :|
    • 8o
    • =O
    • <X
    • ||
    • :/
    • :S
    • X/
    • 8)
    • ?(
    • :huh:
    • :rolleyes:
    • :love:
    • 8|
    • :cursing:
    • :thumbdown:
    • :thumbup:
    • :sleeping:
    • :whistling:
    • :evil:
    • :saint:
    • <3
    • :!:
    • :?:
    • :glaskugel: