GrandMA2 3.1.2.5 Artnet Input

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • Hallo Leute,

    Ich arbeite gerade etwas mit grandma2 onPC 3.1.2.5. In dieser version ist es möglich ohne Orginale Hardware Artnet auszugeben.

    Dies kann man über eine xBelibige software mit eine Interface in DMX umwandeln. Nun möchte ich einen Midi Controller anschließen und diesen in Grandma2 über Artnet einbinden.

    Über den ArtNetominator seh ich dass Artnet signal so wie es sein soll. In Grandma2 onPC funktioniert es aber nicht.

    Könnt ihr mir da weiter helfen ?

    Vielen Dank im Vorraus

    LG

    Pascal:)

    Wenn Gewalt nicht hilft, hilft mehr Gewalt

  • Hallo Pascal,

    warum genau möchtest Du den Controller per ArtNet anbinden? Wäre normales Midi/Midi USB nicht effektiver?!
    Gern kann ich Dich in die MA-Midi Welt einführen, welchen Controller hast du denn und was genau damit vor?

    Ich hätte auch großes Interesse an der Software, da Capture-Visualisierung Parameter zur Darstellung braucht, mit der Version müsste ich nicht immer die Konsole mitschleppen... :)

    Beste Grüße
    Valentin

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.