can i link a scean and a chase together so when i press one button it will play both at the same time
Chris
Linking scean and a chase togeter to a button
-
chris.paul -
March 14, 2019 at 7:59 PM -
Thread is Resolved
We proudly present: The release of DMXControl 3.3.3!
On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!
-
Hi!
To start both (but not end both!):
- create a new chaser (e.g. name it "starter")
- add the step "command" => "Chasers" => <Name of it> => "Start"
- add the step "command" => "cue library" (or "cue list") => <name> => "Start"
- Click on the chaser name and unselect "Repeat".
- Set the duration of both "command steps" to 0|0|1 (by selecting the step, then on the right side)
If you start this chaser with the button, it will activate both.
The command-steps are very useful and mighty. Just try arround a little bit.
Hoc
-
Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
