Hallo,
wieso gibt es bei Automatisch erzeugt bei Lauflicht (RGB)
den Button Auswahl merken und bei Lauflicht nicht.
Hätte mir beim letzten Projekt schon etwas geholfen.
Waren doch einige Dimmer-Kanäle in der Geräteliste.
Gruß Steff
Auswahl merken
-
Steff -
May 18, 2016 at 12:14 AM -
Thread is Resolved
We proudly present: The release of DMXControl 3.3.3!
On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!
-
Souko April 9, 2018 at 8:41 PM Moved the thread from forum Softwareentwicklung [v2] to forum Development and Features [v2]. -
Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
