Effects

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • I'm the new guy on the block, so please be gentle.

    I don't get or see the difference between fade in time and duration in the effects window.

    Could some one exlain it?

    When I move a device in the graphics view it tend to fall off the cursor if I move the mouse to fast.


    Thanks,
    Mac

  • Channels can be "fadeable" or "non-fadeable". This is defined for each channel in the DDF.
    During the "Fade-In-Time" the "fadeable" channels are softly blended from the current level to the target level of the current scene. For example a PAR-Spot would increase it's brightness in this time. The "hold-time" defines how long the scene should be shown before the next one fades in.

    > When I move a device in the graphics view it tend to fall off the cursor if I move the mouse to fast.

    Simply click on the device icon and hold the button while you move. This is a windows-behaviour.

  • I was just about to reply to my own question. I experimented enough to figure it out.

    After running a set of scene changes, how do I get the subs to reset to the initial state.

    The only way I've found is to close the Scenes window. Or, set the first scene change to my "default" and have the set repeat.

  • Oh, and the recommendation about moving the devices in the graphics window is exactly what I'm doing. But the moving graphic doesn't keep up with the cursor. In addition the roll over pop ups don't seem to go away sometimes. Sometimes they just sit there.

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.