Transceiver mit AVR-Studio programmieren

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • Welche Einstellungen bei den Fuses muss man denn nun mit dem AVR-Studio 4.18 einstellen. Ich komme da einfach nicht weiter und habe wahrscheinlich schon 2 ATMEGA8515 ver-fused.

    Bitte Hilfe

  • Ich glaube, nur BOOTSZ0 und BOOTSZ1 müssen programmiert sein (also 0)
    Das entspricht einem HIGH Byte von 0xF9
    und einem LOW Byte von 0xFF

    Bei mir AVR Studio 4.15 kommen diese Werte bei:

    S8515C ( )
    WDTON ( )
    SPIEN
    EESAVE ( )
    BOOTSZ Boot Flash size=1024 words Boot address=$0C00 (der einzige Wert, der nicht standard war)
    BOOTRST ( )
    CKOPT ( )
    BODLEVEL 2.7V
    BODEN ( )
    SUT_CKSEL Ext. Crystal/Resonator High Freq.;Start-up time: 16K CK + 64ms


    Viel Erfolg

    Genesis 1:3 Und Gott sprach: "Es werde Licht!" und es ward Licht (...oder nicht). 4 Und Gott sah, dass das Licht gut war;

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.