Neue Version des Ausgabeplugins fürs Enttec Pro

We proudly present: The release of DMXControl 3.3.3!

On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!

Markus M.

Administrator

Reactions Received

4

Posts

2,600
June 6, 2010 at 8:34 PM
- #1
Hallo zusammen,
ich habe gerade das Ausgabeplugin vom Enttec Pro etwas verbessert.
In der alten Version kam es zu einer Fehlermeldung, wenn man das Interface während der Ausgabe abgezogen hat.
Diese habe ich nun behoben.
Ansonsten hat sich nichts verändet.
Gruß
Markus
Files

EnttecPro.out.zip 11.57 kB – 251 Downloads

Proxy-listen.de
Quote
Souko April 9, 2018 at 8:41 PM

Moved the thread from forum Softwareentwicklung [v2] to forum Development and Features [v2].
Guest
Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
Smilies

Default Category

DMXControl

Your browser has JavaScript disabled. If you would like to use all features of this site, it is mandatory to enable JavaScript.

We proudly present: The release of DMXControl 3.3.3!

Souko April 9, 2018 at 8:41 PM

Souko April 9, 2018 at 8:41 PM