AVR mit MyMultiProg brennen

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • Hallo,
    Ich habe mir das USB-DMX Interface gebaut soweit ist auch alles fertig allerdings muss ich noch den AVR bescheiben, dafür habe ich mir von Conrad einen MyMultiProg LPT besorgt allerdings verstehe ich nicht wie ich die Fuses und alles andere mit der Software setzten muss. Kann mir jemand sagen wie ich das machen muss.

    MfG Christian

  • Ich meinte das DE interface. Das Problem ist das die Software vom MyMultiProg, um genau zu sein das setzten der Fuses den mit dem Bild was beim Projektarchiv dabei ist kann ich recht wenig anfangen. Dasher das ganze in dem Programm von denen ganz anders ist.

    EDIT: Das Problem hat sich gelößt ich musste mich nur dem Fuses Calculator von engbedded.com behelfen.

    Edited once, last by Chrisd (January 5, 2009 at 8:39 PM).

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.