bild in Magic 3D

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • Hi zusammen,

    ich hab da mal ein Problem und zwar in Magic 3D wenn ich da den Varyscan P6 hernehme und dann den Dimmer anmache und die Iris öffne kommt sofort ein bild wie beim Prisma obwohl das Prisma nicht eingeschaltet ist. Was ist da jetzt Falsch eingestellt, oder ist das einfach so?

    mfg Klaus

  • Vielleicht solltest du mal die Kanalübersicht kontrollieren oder mal die Settings in Magic 3D prüfen von dem Teil.

    Andernfalls solltest du dich beim Hersteller melden und nicht hier =) xD

    Veranstaltungen, DJ's, LJ's, Lichttechnik, Soundsysteme:

    Homepage: http://www.djs-2nite.de/ 2n!te is your n!te! Wir machen die Nacht zu Ihrer Nacht!

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.