How to make a plugin for the new interface?

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • I have some wireless RGB LED lights that I would like to control with your software. The wireless controller has RS 232 and Ethernet interfaces but uses a proprietary command syntax and protocol. Would it be possible to develop an interface plugin that is compatible with my wireless controller?

    Kind regards,
    Bojan

  • do you have some more information about the wireless interface and the protocol.

    I am sure that either myself or another member of the DMXControl team could write a plug in.

    Richard

  • Richard,

    Thanks for the reply. Yes, I have the protocol documentation. The protocol is pretty simple. Should I email it to you?

    Thank you,
    Bojan

  • I write new OpenDMX plugin, but I need someone to test it,
    now it is possible to select right interface if multiple OpenDMX is connected to PC. This feature work only if interface has programmed serial number (FT232BM must have EEPROM programmed, FT232C has serial number programmed from manufacturer) - this is limitation of FTDI driver, thah distinguish interfaces by SN. If you have IF without serial number, use "#0" and plugin use first interface found.
    Plugin was tested with CDM2.2.4 driver downloaded from FTDI ( https://forum.dmxcontrol-projects.org/www.ftdichip.com ), with older driver should't work properly, because of changes and additions in FTDI API.

    I currently don't have enought time to testing and futher development, so I post here last version thah should work, but it is not tested in real DMX instalation.

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.