Motion Scene- point control?

We proudly present: The release of DMXControl 3.3.3!


On September 29, 2026, we held our release show for DMXControl 3.3.3. During our usual “hour-long” session, we showed you all the new features in this version and what it now has to offer.
Read all about it in the corresponding news article: We proudly present: The release of DMXControl 3.3.3!


  • In a motion scene once points are drawn,
    the controller fades from one point to the next,
    From a point at 1 to a point at 10 it fades 1,2,3,4,5,6,7,8,9,10-
    as it should.

    Would it be possible to add a mode button to make it
    so only the individual point commands are sent, instead of faded to?

    1, 10.

    Some of my scanners freak out when given constant pan tilt commands, no matter if the pattern is slow or fast.

    Wondering how to adjust the amount of signals they are receiving...

    :)

  • The ones having trouble are 4 ADJ Emerald Scan lasers.
    The model with a XY scanner head on top.

    My minspots love it.

    I would like it to just give the individual XY point commands,
    instead of fading between them, as an option. I believe that would be simplest.

    I could then alter the rates and speeds at which they trigger point to point using the already available commands. These units have no movement vector speed selection, but if they did, I could then alter vector speed via the Point Scenes within Motion Command... right?

    I would really like to use Motion Command as it contains the "scene step offset" per fixture.

    I don't know, if applied, where the best place to put the option would be.
    Inside motion command - ultimately per fixture somehow...

    Simpler would be just within the motion command near the positioning display, 'Point Step' uh 'Points Only' um 'Snap to Points'

    If I have multiple fixtures on same motion, some with and some without 'pont step', I could just build two identical motion scenes, one with one without point step fixtures.

  • Newly created posts will remain inaccessible for others until approved by a moderator. The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.