Electricity Parameters

Good morning!

I hope, I can answer your question so far well - especially the second and third one I am not quite sure because I didn’t use the electricity feature so recently and I also didn’t write something about them for our Wiki.

Quote from Shween

is there a way to change the Power-Source Voltage from 230 to 120 for American Standards?

For the moment, there is no option available. So the calculation is based on the 230V-System.

Quote from Shween

Also, what is the "Send to Ammeter" option for?

Here I am not quite sure, what you mean. But there is a separate window with the name electricity, where you can see the value for each circuit you create.

Quote from Shween

Also, in the electricity Input Assignment Nodes, What is "Ping" input?

In the Input Assignment, you can use them your lighting a signal lamp on a Softdesk, when there is a overload.

If you have some further questions, please ask.

Stefan

Quote from Shween

from 230 to 120 for American Standards?

A workaround somehow is to not use the Amperes display but the Watts display - just double click the ampere meter and it will turn to a watts meter. Sadly you will have to do this every session, as this switch isn't saved.
So you can double the possible amps for your source and get the correct watts scaling (for overload)

Quote from Shween

I have a few questions, but to start, is there a way to change the Power-Source Voltage from 230 to 120 for American Standards?

Hmmm ok, we forgot that Could you please add a ticket in our bugtracker, that we add different Voltage options to this feature?

By the way... I just take now a look into our (German) Wiki.. There is indeed a quite long article about this feature: Lastmanagement (Electricity Management).

Maybe you can find some more informations there.