i would like to know how to connect a laser to the computer to work with laser simulation
-
-
Hi!
I think you mix up two things.
With a "laser simulator" you just simulate the behaviour of a laser with a videobeamer. This is much safer an cheaper. Or you connect a real laser to your computer or DMX and control ist there. This is much more expensive an on most of the lasers that look good you need special licenses to operate them. It could be very dangerous to hurt people.Hoc
-
It could be very dangerous to hurt people.
... to hurt people permanently! Be very careful with lasers - an eye damage through laser is irreversible and causes pain the rest of the life!
-
but how i use with DMX Control software because i know there is a laser simulator plugin. but i would like to know if this tools works via a dmx controller a witch one The laser will be progected on a wall and yes there are security mesurements
-
Souko
Moved the thread from forum Feedback und features [v2] to forum Praise and Criticism [v2]. -
Souko
Moved the thread from forum Praise and Criticism [v2] to forum Development and Features [v2].
-
Newly created posts will remain inaccessible for others until approved by a moderator.
The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
