Hi everyone, I hope to write in the right section, it result very hard for me to figure out where people are speaking about Art-net and developing it.
Well I need a very simple program, able to produce and send a Artnet packet, when some values in RAM changes. This is because I'm using a lighting manager that doesn't support Artnet (only DMX) and I see it's very simple to catch the RAM location with DMX values, I just need to send them into the laser emulator to manage it.
If anyone may kindly help here, thank you a lot!
Input values:
Number of DMX channels
Starting RAM location
IP destination address
Checking values for changes every X milliseconds
Output:
Artnet packet containing all DMX values if one of them has been changed
Need develope program to send some RAM values to Art-net
-
- DMX Multiplexer
- Barabba
- Thread is marked as Resolved.
-
-
About which Software are you talking about?
I have written some Software, that do exactly what you have discribed.
Gruß
Scyte -
thank you fro reply! About Lightjockey 2.95, unfortunately it supports only DMX hardware to output, but opening the RAM I catch the locations with DMX values placed in order, and wven if I restarted the softwar was the same location
-
I really hope somebody can help me, Gruß do you really developed it?
Thank you -
gruß = greeting/greets
sorry, i can´t help you
-
Thanks! I don't know German at all )))
Hopefully Scyte will help, he maybe already developed something, I just need to open the RAM page of a particular application and read ar certain value.. then trasmit it by Artnet..
hopefully it may help all peple who still use LJ 2.95 -
Souko
Added the Label DMX Multiplexer -
Souko
Moved the thread from forum DMX Multiplexer to forum Digital Enlightenment. -
How about an DMX-Artnet controller ? Look at Ulrich Radig website. I have four and they work fine.
-
Newly created posts will remain inaccessible for others until approved by a moderator.
The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.