Hi,
ok, I've done some tests with DMXControl 2, DMXControl 3 and the Windows Beamertool. I can establish a connection between DMXControl 2 and Beamertool via Artnet. All one have to do is to start DMXControl 2 first, set the Broadcast-Adress in DMXControl 2 to 255.255.255.255 (the all-net broadcast adress) and activate the Plugin. With this (and of corse the identical Sub-Net and Port) DMXControl 2 shoult send Artnet-frames to 255.255.255.255. I tested this with Wireshark and filter artnet-frames (Wireshark can detect and separate Artnet-frames). Now go into the Beamertool folder and delete the config-folder. Now you can start the Beamertool with admin-rights. It should now receive artnet-frames. The interessting thing is, that if you restart the beamertool, it often does not get any frames anymore. Sometimes it helps, if you delete the config-folder again. Well this is not a realy good connection. So I personaly think, the current Windows-Beamertool-version is only for some short tests. The much better version is the RPI-version.
Unfortunately, I could not establish a connection between DMXControl 3 and the Beamertool. DMXControl 3 only sends to the Broadcastadress of the local network (xxx.xxx.xxx.255, not 255.255.255.255). This should be the reason, why the Beamertool does not get any packets.
regards
JP