Hi
I just bought a DMX Strobe , specifically the BoomTone 1500W strobe , although by the looks of it , its the same model sold
by many companies.
It only has two channels , Speed and Brightness , how can I achieve a cue in DMXControl that allows me to strobe it once?
Thanks
Sent from my iPhone using Tapatalk
Hi,
in my case the Strobe is intelligent enough to reset the strobe phase each time I raise the brightness channel from 0 to a value. This means, that each time I turn it on the strobe begins immediatly to flash. Now it's just a matter of timing. I wrote an effect, that turns the strobe on for a very short but definite time an turns it back off.
Greetings
MWSysTech
JPK
Newly created posts will remain inaccessible for others until approved by a moderator.
The last reply was more than 365 days ago, this thread is most likely obsolete. It is recommended to create a new thread instead.
