Ok I Hooked up my Artnet output Device
I was able to get Universe #1 to work, But NOT Universe #2 ,,,,unless I selected it but than #1 would not work!
so I don't know What I need to do with Dmxcontrol v2?
do I need two artNet output plug setup?
Ok here are my settings Network, Artnet Device, Dmxcontrol
I hope its a easy Fix
Thanks
Steve
EitherNet Hud Settings
[Blocked Image: http://i307.photobucket.com/albums/nn297/steve-kds/1%20Network%20Address.jpg]
ArcNet Device Settings
[Blocked Image: http://i307.photobucket.com/albums/nn297/steve-kds/2%20Electron-Design%20Device%20Control%20Pic%20resize.jpg]
Dmxcontrol Software Plugins - This is the Original ArtNet Plugin- Works Great But Only 1 -Universe Works (Need to use Updated Drive for 2 -Universe)
[Blocked Image: http://i307.photobucket.com/albums/nn297/steve-kds/1%20DmxControl%20Actnet%20settings.jpg]